Flexible Silicone 4 inch baby press mold with instruction
guide.This is an easy mold to use but does take a little practice
its virtually non stick with no need for Talc or water as the Baby
figure falls out on its own. There's also no need to use armature
wire, and the figure comes out great every Time. Please not the mold
colour may vary from the listings image. This molds is made from
flexible silicone rubber and is extremely hard wearing and should
not split or tear under normal conditions and will last for many
many presses It can be used for practising and to get the feel and
dimensions of micro baby sculpting if it is proving difficult to
master. The molds can also be used to make 4" inch Micro babies to
keep or to sell. The set comes with a brief instruction guide. It
can be used endlessly to produce countless copies and therefore
should prove to be good value and a one off purchase for any
practising sculptor or micro Baby enthusiast You can also add your
own touch to the finished baby by adjusting the pose, wrinkles, etc.
before baking in the oven. Please note these molds are not suitable
for liquid plasters or slip and are sold suitable for good quality
polymer clays. This is quite a chunky Heavy mold and measures 5 1/4
inches x 3 1/2 inches and weighs almost half a Kilogram Finished
Baby measures 4"with bent knee and 4.5" with straight legs.