70mm Silicone Baby press mold

Flexible Silicone 70mm baby press mold with instruction guide.
This is an easy mold to use its virtually non stick with no need for Talc or water
as the Baby figure falls out on its own. There's also no need to use armature wire,
and the figure comes out great every Time. Please note the mold colour may vary from the listings image. This molds is made from flexible silicone rubber
and is extremely hard wearing and should not split or tear under normal conditions
and will last for many many presses It can be used for practising
and to get the feel and dimensions of micro baby sculpting
if it is proving difficult to master.
The molds can also be used to make 70mm Micro babies to keep or to sell.
The set comes with a brief instruction guide.
It can be used endlessly to produce countless copies
and therefore should prove to be good value and a one off purchase
for any practising sculptor or micro Baby enthusiast
You can also add your own touch
to the finished baby by adjusting the pose,
wrinkles, etc, before baking in the oven.
Please note these molds are not suitable for liquid plasters or slip
and are sold suitable for good quality polymer clays.