Flexible Silicone 95mm baby push mold with a brief instruction guide.This is an easy mold to use its virtually non stick with no need for Talc or water as the Baby figure can be pushed out easily.There's also no need to use armature wire. This molds is made from flexible silicone rubber and is extremely hard wearing and should not split or tear under normal conditions and will last for many many uses Please note the colour of the mold may vary from the listings image. It can be used for practicing and to get the feel and dimensions of micro baby sculpting if it is proving difficult to master. The molds can also be used to make 95mm Micro babies to keep or to sell. The set comes with a brief instruction guide. It can be used endlessly to produce countless copies and therefore should prove to be good value and a one off purchase for any practising sculptor or micro Baby enthusiast this mold is suitable for good quality polymer clays and liquid plasters The mold produces a Baby figure of 95 mm sleeping on its tummy with one flat side.(tummy)